WELCOME TO GOSDAR MFG. CO., LTD |
Expert moulds maker of tube unscrew closures molds moulds tools tooling , tube flip top caps closures lids covers molds moulds tools tooling , bottle unscrew closures lids covers molds moulds tools tooling, bottle flip top caps closures lids covers molds moulds tools tooling, child resist closures lids covers molds moulds tools tooling, disc top caps closures lids covers molds moulds tools tooling, plug shoulder molds moulds tools tooling, pharmacy bottle closures caps lids covers molds moulds tools tooling, tamper evident caps closures lids covers molds moulds tools tooling, blowing bottle molds moulds tools tooling, lipstick container cases molds moulds tools tooling, cream jars caps closures lids covers molds moulds tools tooling, make up compact molds moulds tools tooling, hot runners special caps closures lids covers molds moulds tools tooling etc. |
|
|
Molds Make Experiences |
|
|
|
|
Molds Make ExperiencesShowroom4 |
|
|
| Cap mould experience FAQ | |||
|
|
|
|
? |
|
|
|
Cap mould experience FAQ |
|
|
|
Cap finger location not in the face of bottle! |
|
|
Problem: The rotate screw pin teeth not in a same position when install the mould. |
![]() |
|
Solutions: 1) First the rotate screw pin teeth should in a same position when install the mould. 2) When the mould run, the hydraulic motor run how much, the mould should run back the start position how much. |
![]() |
|
Problem again: Still have 1 or 2 cap not in the center of bottle |
![]() |
|
Solutions again: Must disassembly the mould than adjust the gear that have problem. |
![]() |
|
|
|
|
|
|
|
Copyright © 2000-2012
|